Hi Hat Upper Tube

[billcosby_sweater]

I recently got a DW 5000 Hi hat stand but it comes without some parts since it was used. I measured and it seems a tube around just over an inch thick would fit nicely. Nothing more than an inch and an 1/4 I would say. Ideally the tube would come attached with the bottom plate that the hi hat rests on.

 

[Tama CW]

You should get the exact measurement on the center tube OD. A standard ruler in mm and inches should be good enough.

https://www.google.com/search?clien...kEHbGkDI8QBSgAegQIARAy&biw=1920&bih=899&dpr=1

 

[billcosby_sweater]

You should get the exact measurement on the center tube OD. A standard ruler in mm and inches should be good enough.

https://www.google.com/search?clien...kEHbGkDI8QBSgAegQIARAy&biw=1920&bih=899&dpr=1

Seems like an inch and a quarter I wouldn't mind if it was smaller though because the outer tube can tighter to almost fit a tube that is half an inch. Ideally thought I don't want to crank the screw to get it to fit something that small so anything from an inch to an inch an a quarter.

 

[premierplayer]

DWSP357 (complete assy)

https://manualzz.com/doc/45910450/5500d-dw-hi-hat-stand

 

[billcosby_sweater]

Decided to bite the bullet and buy a full priced one off of The Drum Center Of Portsmouth.